ENGLISH
OPERATION MANUAL
BRITEQ
®
3/12
BT-COLORAY MULTI
DESCRIPTION:
1. MAINS INPUT:
equipped with original Neutrik TRUE1 PowerCON
®
. Connect the supplied mains cable or
any TRUE1 PowerCon
®
extension or combi cable here.
2. MAINS OUTPUT:
equipped with original Neutrik TRUE1 PowerCON
®
. Used to daisy chain the power to
several other projectors. Always pay attention to the maximum load while adding projectors! Special Multi
cables (TRUE1 PowerCON
®
+ DMX XLR-cables are optionally available: see our website!)
3. AIR PRESSURE VENT:
for improved performance and service life, this special vent equalizes the
pressure inside the projector while blocking water and preventing condense from being formed.
4. DMX IN:
3p XLR connector used to connect the projector with other units or a DMX-controller. The DMX-
input is also used to update the firmware of the projector, see the upgrade instructions on our website.
5. DMX OUT:
3p XLR connector used to daisy chain the projector with other units.
6. DISPLAY & BUTTONS:
alphanumeric OLED-display and backlit touch keys to select different options of
the setup menu:
•
MENU-button:
used to enter/exit the setup menu.
•
▼-button:
used to go to the next menu option or to decrease a parameter value.
•
▲-button:
used to go to the previous menu option or to increase a parameter value.
•
ENTER-button:
used to select a menu option or confirm a setting.
Remark: to rotate the display
over 180°, press the ▲-button while the standard display is shown.
7. HANGING BRACKET:
with nuts for the use of the (optional) Briteq Omega Bracket Small (code: 02677).
you can use the hole in the center of the bracket to fix a hook or truss clamp.
8. SAFETY EYEBOLT:
used to attach a safety cable when the unit is rigged (see paragraph “overhead
rigging”
9. OMEGA BRACKETS:
use these holes to install a Briteq® Omega Bracket Small (code: 02677).
10. MOUNTING FRAME:
used to install the different accessories that are included. When you use these,
always make sure that the safety clip is well closed and located on the upper side before you install the
projector!
11. COMPOUND EYE LENSES
: two different lenses (15° and 35°) can be installed to obtain a more narrow
beam.
12. GLARE SHIELD:
used to make a better aligned beam and/or avoid unwanted glare. Can be used in
combination with the lenses or gel frame.
13. BARNDOORS:
(optional part: order code: 5527) can be installed to delimit the beam in certain directions.
Can be used in combination with the lenses or gel frame.
