25
24
Care aand M
Maintenance
Care aand M
Maintenance
C
Coovveerr R
Reem
moovvaall
1
Loosen the harness by pushing the harness release button while
pulling the shoulder straps forward as far as possible.
2
Unhook the shoulder straps from the yoke on the rear of child
restraint.
3
Remove the belly pad from the buckle.
4
Pull upper harness straps through the shell and cover, to the front
of the restraint.
5
Gently remove the upper portion of the cover. Be careful not to
damage the energy absorbing foam.
6
Pull the lower harness straps, buckle tongues, chest clip, buckle, and
belly pad through the slots in the cover.
WARNING:
•
Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
•
Never remove the buckle tongues from the harness. They can-
not be reattached after removal.
7
Remove the entire cover from the restraint.
R
Reeffiittttiinngg tthhee C
Coovveerr
To refit the cover, reverse
Cover Removal
directions. Make sure that
the shoulder straps are threaded through the chest clips and that
the harness is not twisted.
B
Buucckkllee R
Reem
moovvaall
1
Fully recline the child restraint.
2
Locate the metal buckle strap
retainer on bottom of the
restraint.
3
Pull retainer away from child
restraint to loosen.
4
Turn the retainer so that the short side will go through the slot
in the restraint shell (
Fig. A
).
5
Push the retainer through slots in the shell and cover, to the front
of the restraint.
R
Reetthhrreeaaddiinngg tthhee B
Buucckkllee
1
Locate the necessary buckle slot.
2
Turn the buckle retainer so that the short side will go through the
slot in the cover and restraint shell (
Fig. A
).
3
Pull buckle away from restraint until tight, then verify that the
strap is not twisted and the release button is facing outward.
A
P2170_EXP_R01.qxd 5/21/2007 9:31 AM Page 26
