2
P05331600_A:12.17
REMOVE SNACK TRAY
1. Prepare stroller
Set parking brake, rotate canopy towards handlebar
(see stroller user guide if necessary).
2. Remove Snack Tray
Empty tray of all contents. While holding release
buttons on both accessory adapters at sides of
stroller, pull Snack Tray forward and out of receiver
sockets, keeping alignment even left to right as you
pull (Fig. 5).
NOTE:
For strollers manufactured prior to September
2015, slide the covers at the front of the stroller
accessory adapters up to cover the receiver sockets
(Fig. 1).
CARE INSTRUCTIONS
Clean with soap or mild detergent, rinse with warm water. Air dry before use. Snack Tray is not dishwasher safe.
LIMITED WARRANTY
BOB Gear by Britax takes pride in its workmanship and strives to manufacture the best products possible. Therefore, we
warranty our Snack Tray against defects in material and workmanship subject to the conditions listed below. Since no product
is indestructible, it does not cover defects attributable to or resulting from normal wear, abuse or alteration.
The Snack Tray is warranted for one year from the date of original purchase. Warranty is only valid for the original purchaser. Proof
of purchase is required to exercise this warranty. Labor and freight charges are not included.
Normal wear, neglect, abuse, accidents, improper use are not covered by this warranty. Warranty claims must be made
through BOB Gear by Britax customer service. This warranty is limited to the repair or replacement of the defective part. BOB
shall in no event be responsible for consequential or special damages. This limited warranty is the only express or implied
warranty applicable to BOB. Any implied warranties, including warranties of merchantability and fitness shall be limited in
scope and duration in accordance with this limited warranty.
B.O.B.
®
, BOB
®
, BOB Gear
®
, Britax
®
, and Duallie
®
are trademarks owned by BRITAX and are registered in the U.S.A. and/or Canada. All rights
reserved. ©2017 Britax Child Safety, Inc.
INSTALL SNACK TRAY
1. Prepare stroller
Set parking brake, rotate canopy towards handlebar
(see stroller user guide if necessary).
NOTE:
For strollers manufactured prior to September
2015, slide down the covers at the front of the stroller
accessory adapters down to expose the receiver
sockets (Fig. 1).
2. Align locking end caps
Align each locking end cap on Snack Tray with the
respective accessory adapter receiver socket (Fig. 2).
3. Attach Snack Tray
Push locking end caps straight into receiver sockets
fully. A click should be heard on each side (Fig. 3).
4. Verify proper attachment
Pull on front of tray to verify tray is securely locked into
place (Fig. 4).
2
4
5
1
Receiver
socket
covers
3
