HOW TO USE
41
TO RECLINE RESTRAINT
The child restraint may be reclined or positioned upright
without removing the child from the restraint. Lift grey
recline latch and push or pull to get the desired recline.
There are 4 recline positions including upright. You will
be able to gain partial recline from upright position lifting
the grey recline latch up and pulling the seat forward
(see page 13). The extent of the recline will be limited
by the location of the anchorage point. Loosening of the
upper anchorage strap may be required when positioning
the restraint to either an upright or reclined position.
Once the required position has been determined always
tighten the upper anchorage strap, tighten the car's
seatbelt and close the lock-off.
TO REMOVE RESTRAINT FROM
VEHICLE
A.
Disengage seatbelt tongue from buckle and remove
the seatbelt from the restraint.
B.
Release the stored strap and fully press upper
anchorage strap adjuster button (A) while pulling
upper anchorage strap (B) to slacken as shown right.
In some vehicles loosening of the upper anchorage
strap may be difficult. If so, try pushing the restraint
against the vehicle seat back or slightly lifting the
restraint to release the tension.
C.
Disengage the attachment clip from anchor fitting. The
child restraint is now disconnected.
Lift grey recline latch up while moving
restraint into desired recline position.
Lift Grey
Recline Latch
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
B
A
Storage
Band
B
FORW
ARD F
ACING
Summary of Contents for 7200/A/2010
Page 58: ...58 NOTES ...
Page 59: ...59 NOTES ...
