56
57
D.
Feed the straps through the Gated 3-Bar Slide to
remove any slack.
Use this seat belt configuration to install the child restraint
according to the instructions on pages 22 to 23.
Sash belt
portion
Lap belt
portion
When fitting the Curved Gated Slide, the seat belt route
can only go one way, as shown above.
ALTERNATIVE INSTALLATION IF SEATBELT LOOSENS
Remove the gated 3 bar
slide from the seat belt as
soon as the child restraint
is removed so that an
adult can use the seat belt
as a lap-sash seatbelt.
IMPORTANT:
ALTERNATIVE INSTALLATION IF SEATBELT LOOSENS
LAP-SASH SEAT BELT
If a seat belt will not stay tight, then a
Gated 3-Bar Slide may be used to prevent
loosening.
There may be two types of Gated Slides
available, Curved and Flat.
Before installing the restraint, join the
lap-sash seat belt by using the Gated 3-Bar
Slide stored under the carrier.
Hollow side
Inner
strap
A.
Hold the lap and sash straps together and fold
as shown. Slide the inner strap into the Gated
3-Bar Slide followed by the outer strap.
B.
The two straps should slide freely in the Gated
3-Bar Slide slot.
Faces
towards
restraint
C.
Repeat previous step A for the other
slot in the Gated 3-Bar Slide.
Ensure the Lap portion of seat
belt is nearest to the restraint
Curved
Flat