6
Need help?
Give us a call on
0330 026 6273
and speak to one of our trained advisors.
Pack Contents
x2
1. Identify all components are present prior to
starting installation.
2. From the fixing kit, screw the two fixing rods
into the bottom of the mixer body. Screw in
(by hand only) the flexible connecting pipes
to the mixer body by hand only; (DO NOT
OVERTIGHTEN).
3. Feed the mixer body through the basin
taphole ensuring the o-ring is fitted in the
groove on the underside of the tap body.
4. Push the ‘C’ shaped rubber and metal
washers onto the threaded rods and tighten
by screwing the fixing nuts.
5. Connect the hot and cold
water supplies to the tap
tails. We recommned
fitting isolation valves for
ease of future maintenance
(not supplied).
6. Fit the clicker waste to the basin ensuring a
rubber washer is fitted between the basin
and the waste.
7. Place the other rubber washer under the
basin and secure in place by tightening the
backnut.
8. Turn on the water supplies and open both
taps letting the water flow for a few minutes
to check all joints and connections for any
leaks.
x1
REMEMBER
Hot on the
left, cold o
n
the right!
Operation
Cold
Hot
On
x1
x1
x1
Push down
the plug to
fill the basin.
Push again to
empty.
Installation - Basin Mixer