BriskHeat
®
Corporation. All rights reserved
4
TB4000 Bulb and Capillary
Temperature Controller
Sensor Location:
Position and attach bulb temperature sensor directly on top of the heater or
touching the edge of the heater while also contacting the surface being heated.
Temperature sensing bulb must be in close proximity of heater for accurate
temperature control and to prevent over-heating. Use appropriate
temperature- rated adhesive tape to attach bulb or for large tanks and vessels
use a bulb bracket (available from BriskHeat
®
)
.
If you have questions
concerning your application please contact your local distributor or BriskHeat
®
at 1-800-848-7673 (U.S. & Canada), 1-614-294-3376 (World wide), or
[email protected].
Electrical Connections:
Holes for conduit and fittings may be made using a standard hole saw. Take
care to avoid damaging components when making holes.
Heater Connections:
Connect heater wires to the proper terminals. Proper over-current protection
should be located in the supply lines. Contact your local distributor or
BriskHeat
®
at 1-800-848-7673 (U.S. & Canada), 1-614-294-3376 (World wide),
or [email protected] for additional assistance.
Alarm Connections (If applicable):
On all models with the alarm feature, the loose wire must be connected to the
proper terminal on the terminal block for the light to function in the proper
manner. Refer to the electrical diagram on the next page.
On some models, a transformer may be supplied or retrofitted to avoid running
a second alarm supply. Consult the factory for assistance with your specific
installation/application.
DO NOT BEND, KINK, OR CRIMP THE BULB
AND CAPILLARY - This will cause loss of
calibration and might render the controller
inoperative. All warranties will be void if bulb or
capillary is damaged.
INSTALLATION INSTRUCTIONS
Mounting:
The enclosure should be mounted in a suitable location. Be sure that the bulb
will reach the desired sensing area. The mounting holes can be turned to aid
in installation if necessary.
