© BriskHeat
®
Corporation. All rights reserved.
9
SDCE Digital Benchtop Temperature Controller
Maintenance:
Dirt, oil, grease or other foreign matter can be removed with a damp rag and mild household
cleaners.
NOTE: The device should be unplugged prior to cleaning with a damp rag and allow to fully dry before
being energized.
Inspection:
Perform before and after use of the controller.
The cables and wires should not have any visible breaks in their insulation.
The casing and control should be free of any cuts, cracks or punctures.
Storage:
This product should be stored at room temperature in an environment with less than 80% relative
humidity.
Disposal:
This product must be recycled in accordance to 2012/19/EU Waste Electrical and Electronic
Equipment (WEEE) directive.
Anyone who reads and understands these instructions
is qualified to maintain this controller.
MAINTENANCE INSTRUCTIONS
ALARM SETTINGS
The alarm displays when the sensing element temperature extends past the High Limit Alarm. This
device’s alarm is identified by the illumination of the AL and OUT2 red LEDs. The alarm settings are
accessed under the Alarm Function (AL.F) parameter. The three available alarm settings are:
AL - Automatic reset Alarm - When the temperature extends past the High Limit Alarm, the alarm
automatically disengages.
AL. n - Latched Alarm - When the temperature extends past the High Limit Alarm, the alarm
display will remain engaged until it is manually reset. To manually reset the alarm, press and hold
both the U and P buttons for 5 seconds.
AL.A - Acknowledgeable alarm - While the temperature is extends past the High Limit Alarm, the
alarm can be acknowledged and disengaged by pressing and holding both the U and P buttons for
5 seconds. The alarm will automatically reset when the temperature returns to within the High Limit
Alarm if it is not acknowledged prior.
© BriskHeat
®
Corporation. All rights reserved.
10
SDCE Digital Benchtop Temperature Controller
EMERGENCY PROCEDURES
Electric Shock:
Do not touch the injured person while they are still in contact with the electrical current.
Call your local emergency service if the injured person experiences: severe burns, confusion,
difficulty breathing, hearth rhythm problems, cardiac arrest, muscle pain and contractions,
seizures or a loss of consciousness.
Minor Burns:
Hold the burn area under cool running water for 10-15 minutes.
Remove rings or other tight items from the burned area.
Major Burns:
Call your local emergency service.
Protect the person from further harm.
Remove rings or other tight items from the burned area.
Monitor breathing and have qualified person perform CPR if necessary.
Fire:
Call your local emergency service.
If it is safe to do so, use a fire extinguisher to extinguish the fire, otherwise evacuate to a safe
distance and wait for help to arrive.
This controller is built from material that will not support a flame, but could ignite nearby
combustible material.
Read and understand these procedures prior to using this
controller. Disconnect power to the heater in the event of an
emergency.