(S3)
a,c
b
b
d
Main Lock Body
Mounting Plate (D)
Main Lock Body
Mounting Plate (D)
Inside Knob
Rose (E)
INSIDE VIEW
a.
f.
e.
d.
c.
b.
Handle Pivot Bolt (S6)
Bushing (G)
Handle
Assembly (F)
Handle
Assembly (F)
Spindle
Connector Plate
Hex Wrench (T1)
Spindle Slot
Outer Rose (J)
(Not provided
with every model)
Screw Post
Tabs
5/16" Hole
a.
Place the Main Lock Body Mounting Plate (D)
over the spindle of Main Lock Body (C) with the
words ‘FACE OUT’ visible. Position the plate
against the door face with the mounting holes
aligned vertically.
b.
For models with a square or rectangular
mounting plate and inside rose, make sure the
straight vertical side of the mounting plate is
parallel with the door edge before fully tighten-
ing the (S3) screws.
c.
Insert the two (S3) Main Lock Body Machine
Screws through the holes in the plate and
engage the threaded screw posts of the Main
Lock Body (C). After making sure the plate is
oriented according to Step 6b, tighten the
screws firmly.
d.
Install the Inside Rose (E) by aligning with the
notches on the Mounting Plate and snapping it
on.
a.
Install Bushing (G) onto the (S6) Handle Pivot
Bolt.
b.
For models provided with an Outside Lower
Rose (J), slip it onto the Mounting Hub. Tabs
protruding into the hole in the rose will align
with cutouts in the Mounting Hub to keep the
rose oriented correctly.
c.
Insert the Screw Post on the bottom of Handle
Assembly (F) into the 5/16" Hole in the door.
(Hole C on the template).
d.
Align the Connector Plate of the Handle
Assembly (F) with the Slot in the Spindle and
carefully insert the Connector Plate into the
Slot. Hold the Handle in place.
e.
Using the Hex Wrench (T1), insert the (S6)
Handle Pivot Bolt and Bushing (G) through the
Bolt Hole in the Spindle from the side that has
the large recess. This side always faces the
latch.
f. The (S6) Handle Pivot Bolt will pass through the
slot in the Connector Plate until it engages the
threads in the opposite wall of the Spindle. Turn
the Large Hex Bolt clockwise until the bolt is
tightened firmly and is flush with the Spindle.
Bolt Hole
(Large
Recess)
Handle Pivot
Bolt (S6)
& Bushing (G)
Install the Main Lock Body
Mounting Plate and Inside Rose
STEP 6
Install Handle Assembly
STEP 7
