IMPORTANT!
45 mm
Notch
35 mm
Notch
Lug
Adjustment
Screw Post
Hex Adaptor
Hexagonal
End Shape
Adjustment
Ring
Screw
Post
Screw Post
Outside Mounting Plate
Hex Adaptor
Threaded Post
a.
Measure your door thickness. It should be 1-3/8"
(35 mm) or 1-3/4" (45 mm). If in between these
numbers, round to the nearest of those two
thicknesses.
b.
Your lockset is adjusted for a 1-3/4" door at the
factory.If your door thickness is about 1-3/4",
proceed to Step 3.
c.
If your door is closer to 1-3/8" (35mm) thick, the
position of the Outside Mounting Plate must be
adjusted. It is held in place by two Screw Posts
which have a hexagonal shape on the end; two
Hex Adaptors are provided so that a Phillips Head
Screwdriver can be used to quickly unscrew the
two posts that hold the Mounting Plate.
d.
Slide the Mounting Plate back. Locate the Adjust-
ment Ring and slide it back also.
e.
Rotate the Adjustment Ring until the two 35mm
notches on the ring are aligned with the two Lugs
on the Main Lock Body. These Lugs are located in
line with the Screw Posts.
f.
Slide the Adjustment Ring against the Lugs.
g.
Slide the Outside Mounting Plate back against the
Adjustment Ring and secure it by screwing the two
Screw Posts back into the Threaded Posts on the
Mounting Plate, alternating between the posts so
that they are tightened evenly. Tighten them both
firmly.
Note:
If the Hex Adaptors are lost, an adjustable
wrench can be used to loosen and tighten the
Screw Posts. Be careful not to overtighten.
Adjust For Door Thickness
STEP 2
