10
6. Repeat steps 3–5 for lighting each burner. Always use electronic igniter for lighting each burner. If
burner does not ignite using the push-button igniter, see “Match Lighting the Main Burners” section.
7. To turn off, turn each control knob clockwise until it locks in the “OFF” position. This does not turn off
the gas fl ow from the cylinder.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting burner.
2. Make sure all control knobs are in the “OFF” position.
3. Place a paper match in the end of the matchlighter. Strike the match and
place through lighting hole in the left hand side of the grill to approximately
1/2” (1 to 2 cm) from the burner.
4. Turn on the
FAR LEFT
burner control knob to the “HIGH” position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to “OFF” and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the “HIGH”
position.
7. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner
and
cylinder.
DO NOT
attempt to operate the grill until the
problem is found and corrected.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the “OFF” position.
3. Push and turn side burner control knob to the “HIGH” position.
4. Press the electronic igniter on the main control panel and hold for
3–5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”, wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting”
section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the “OFF” position.
3. Strike the match and place it approximately 1/2” (1 to 2 cm) from the burner.
4. Push and turn the side burner control knob to the “HIGH” position. The burner should light within 5
seconds.
5. If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the side burner until the
problem is found and corrected.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
Lighting
Hole
Matchlighter
