7
Step 6
Remove all the control knobs from the
control panel and set aside for later use.
Insert stop pin into each control knob
bezel by screwing into threaded hole as
shown.
Step 7a
Figure 1 shows valve stem and bezel
with the control knob removed. Take six
large stop plates from the component
card and place them over all valve stems
except the Sear-X burner as illustrated
(Figure 2). Verify the tab and the stamped
letter on the stop plates face out.
Replace all control knobs except the
Sear-X knob when finished.
Step 7b
Figure 3 shows Sear-X valve stem and
bezel with the control knob removed.
Stop plate has been pre-installed. Make
sure the pre-installed stop plate is seated
properly. Replace Sear-X control knob
when finished.
Step 8a
Carefully replace all burners, making sure
burner openings slide over valve nozzles.
Attach each burner using studs with
cotter pins that were set aside in Step 3.
Note:
The Sear-X burner is different
from other main burners and
must be installed on the
Sear-X valve.
Step 8b
Reattach any electrodes that were
detached in step 3a.
Step 9
Replace warming rack, cooking grills and
heat distribution plates.
Note:
Follow directions in the leak
testing section of this manual
before using this grill.
L
Figure 1
Figure 3
Stop Pin
Stop Pin
Figure 2
Stop Plate
Stop Plate
Stem
Stem
Stop Pin
Cooking
Grills
Heat
Distribution
Plates
Warming
Rack
Sear Burner
Cooking Grill
Sear
Burner Heat
Distribution
Plate
