Brinkmann ProSeries 2500, Owner'S Manual

Page: 23 / 32

22
Step 5
Attach the grease tray bracket onto
the back cart panel by inserting the
three tabs into the slots on the back
cart panel.
Note: When performing Step 6, lift
grill body from front and rear
panels to avoid injury to
hands and fingers.
Step 6
With the help of a friend, place grill
body assembly on grill cart. Grill
body will rest on upper side
sections of cart. Align bolt holes
located on the outside of the grill
body assembly. Secure using four
M6 X12mm bolts. At this point, fully
tighten four bolts holding back
panel from Step 4.
Note: To install battery, unscrew
igniter button cap. Insert
battery with positive end
towards button. Replace
igniter button cap.
Grease Tray Bracket
1. Read and follow all warnings and instructions
in owner’s manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control
knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5
seconds to light burner.
6. If burner does NOT ignite immediately, turn control
knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. Repeat Steps 4-6 for lighting each burner. Always
use electronic igniter for lighting each burner.
8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.
10. To turn off, turn control knobs clockwise until it locks
in OFF position.
GRILL LIGHTING INSTRUCTIONS:
FOR OUTDOOR USE ONLY
Igniter Button Cap
OFF OFF
HIGH HIGH HIGH HIGH
LO LOW LO LOW LO LOW LO LOW
HIGH HIGH HIGH HIGH
OFF OFF OFF OFF OFF OFF OFF
HIGH HIGH
LOW LOW LOW LOW
HIGH HIGH
OFF OFF OFF
1. Read and follow all warnings and instructions
in owner’s manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control
knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5
seconds to light burner.
6. If burner does NOT ignite immediately, turn control
knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. Repeat Steps 4-6 for lighting each burner. Always
use electronic igniter for lighting each burner.
8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.
10. To turn off, turn control knobs clockwise until it locks
in OFF position.
GRILL LIGHTING INSTRUCTIONS:
FOR OUTDOOR USE ONLY
Grill Body