1. The IEC320 connector mates with the
power inlet module (Fig. 13).
Note: The ON/OFF switch should always be
in “OFF” position when installing or
removing the power cord.
Installing Power Cord
Replacing Fuse
1. Pull fuse holder out of power inlet module.
2. Remove fuse holder and check for wear (Fig. 11).
If fuse is blown, replace with a new fuse or the
on-board spare (Fig. 12).
3. Return fuse holder to a closed position.
Figure 11
Figure 13
Note: Replace fuse only with 8-amp, time-delay,
250-volt, 5 x 20-mm fuses.
On-board Spare
Active Fuse
Figure 12
9
Summary of Contents for BL.16
Page 15: ...Notes 15...
