Brightline BL.16, Operating Instructions Manual, Page: 8 / 15

Disconnecting Cables
1. Turn power “OFF” on all devices.
Note: If the fixture power is not turned “OFF” before
connecting or disconnecting the DMX cable to the
fixture, damage to the ballast may result.
2. Insert the male plug end (Figure 1) into the appropriate
female receptacle on the lighting control console.
3. Line up the locking key on the female plug end (Figure 2)
with the male receptacle on the first fixture labeled
“DMX IN.” Insert the plug into the receptacle until it
locks into place.
4. To add additional fixtures, line up the locking key on the
male plug end of the jumper cable (Figure 1) with the
female receptacle labeled “DMX THRU” on the first
fixture. Insert the plug into the receptacle until it locks
into place.
5. Route the jumper cable to the next fixture.
6. Line up the locking key on the female plug end of the
jumper cable (Figure 2) with the male receptacle
labeled “DMX IN” on the next fixture. Insert the plug
into the receptacle until it locks into place.
7. Repeat Steps 4-6 for remaining fixtures.
8. Turn power “ON” on all devices.
Installing DMX Control Cables
Figure 5
Figure 6
3. To disconnect the male end of cable, press in the
release button on the female receptacle (Figure 5) and
pull the plug out of the receptacle (Figure 6). Pressure
should be applied to the plug, not the cables.
Figure 1 Figure 2
Locking Key
1. Turn power “OFF” on all devices.
2. To disconnect the female end of cable, press down the
release button on the plug (Figure 3) and pull the plug
out of the receptacle (Figure 4). Pressure should be
applied to the plug, not the cables.
Figure 3
Figure 4
8