5.
MIX THE SILICONE MOLDING
RUBBER COMPOUND
9
Attach the small impeller to the central shaft on
the polycarbonate lid with the aid of the allen
key. Make sure to properly tighten the screw.
WARNING:
Failure to properly tighten the
screw may result in equipment damage and
malfunction.
Connect the vacuum pump hose to the
horizontal vacuum connector on the
polycarbonate lid. Close the vertical
vacuum connector with the end cap.
Turn on the vacuum pump
(manometer
should reach around 20 PSI). The mixing
glass and the polycarbonate lid will be fully
attached and sealed due to the vacuum.
Connect the polycarbonate lid’s mixer shaft
to the mixer’s motor shaft.
Turn on the mixer for 30 seconds.
During
this process, the color of the silicone mix
may change.
Rest the mixing glass on a flat surface
with the silicone mix in it. Close it with
the polycarbonate lid, placing the small
impeller inside the mixing glass.
1
3
2
4