10
Turn off the mixer switch and disconnect
the polycarbonate lid and mixing glass from
its shaft.
Rest the mixing glass on a flat surface, turn
off the vacuum pump and disconnect the
hose from the horizontal vacuum connector
on the polycarbonate lid.
Pour the silicone mix inside the previously
prepared u-shaped mold frame.
Immediately clean the small impeller and
mixing glass using paper towel. Failure to
do so may result in equipment damage.
Wait for the silicone to dry in the u-shaped
mold frame. Drying time varies according to
the silicone’s manufacturer’s specifications.
Detach the polycarbonate lid from the
mixing glass. Air bubbles in the silicone
should burst, leaving a smooth and
homogeneous silicone mix.
5
7
6
MIX THE SILICONE MOLDING RUBBER COMPOUND CONT’D