Bright Technology cb958b, User Manual, Page: 14 / 28

11
key to realize the unit conversion from inch to mm.
②
The unit conversion of the D of the rim from inch to
mm:
Normally, the display of D should be in inch. When you
need the unit of the display to be mm, you can use the
key to realize the unit conversion from inch to mm.
After unit conversion, the unit of the display values of
rim Br and D are , but when you switch off and then on
the wheel balancer, the unit will be still inch.
③
The unit conversion from gram to ounce
：
Normally, the unit of the unbalance value is gram (g). If
you want to make the ounce(Oz) to be the unit, you can
execute the g/Oz conversion. The unit of the displayed
unbalance value is gram
（
g
）
. The way to realize the unit
conversion from gram to ounce is to press .
6.4.5 When press the start key
，
wheel
balancer starts to run. A few seconds later, the
machine automatically stop. The machine can also
automatically start by lowering down the protective
cover which can be setup by the program.
6.4.6 DISPLAY UNBALANCE VALUE
When the spin ends, the display will display the inner
and outside value of the rim.
Use your hand to pull the wheel. When all the
positioning lamps light inside and outside light, the
weight adding position will be indicated.
6.4.7 Rotate the wheel, when the left side positioning
lamp all light, at this moment, the highest position is the
inner unbalance position and when the right side
positioning lamp all light, at this moment, the highest
position is the outer unbalance position.
6.4.8 Add the corresponding weight at the unbalance
point and start test again until the balance of the tyre.
CAUTION
！
1. When start the machine, use hand to pull the wheel
to help it start rotation, especially to the relative bigger
tyre, to prolong the working life of the motor.
2. Check if there are any mistakes on the dimension.
3. Check if the balance methods meet the configuration
of the rim and select the balancer most easily to
balance.
4. Check if the contract nut tight or not.
5. When the balance ends, remove the tyre. Pay
attention to handle it with gentle and avoid knocking the
main shaft.
6. When clipping the weight. Use the hammer to clip
the weight on the rim without too much force. Place on
the ground and knock and do not knock when it is on
the main shaft to avoid damaging the sensor. The
position to add the weight must be without the grease
and dry.
6.5 UNBALANCE VALUE DISPLAY RESIDUAL
The minimum value of the standard weight is 5g so if
the weight you use is less than 5 g, the wheel balancer
will not display the value and only displays the state of
―00‖. When you need to display the residual unbalance
value, you should press
，
and the display will
immediately display the inside or outside unbalance
value of less than 5g. The maximum residual
unbalance value is 4 g.
6.6 BALANCE MODE SELECT
Select the balance mode according to the weight dding
position and the balance mode. Press the
C
orresponding key to select the balance mode.
When you switch on the machine the machine will
automatic enter into the dynamic balance mode and no
need to select.
Note color to indicate the modified position of the