11
Maintenance
StatStation Maintenance
If alkaline (2200mAH) batteries are used, display console will
operate for up to 40 hours, if the AC/DC Converter is not
used. The transmitter will operate for up to 60 hours after
utility and generator power is lost. A System Alert will be
reported if the transmitter’s batteries are low. The left side of
the display will indicate if the display console’s batteries are
low. Be sure to keep fresh batteries in the components so
your StatStation will be ready for the next outage.
Generator Maintenance
Your StatStation will report the time remaining before certain
maintenance tasks must be performed on your standby
generator. See
Viewing the Maintenance Schedules and
History
in the
Operation
section.
If the time interval for scheduled maintenance has passed,
the StatStation will report System Alerts for scheduled
maintenance and the LED will flash red. An audible alarm will
not accompany Maintenance Schedule System Alerts.
The following table lists the events tracked by the system.
Resetting StatStation after Generator
Maintenance
Follow the maintenance instructions in the operator’s manual
for your standby generator carefully. Then reset the intervals
on your StatStation.
1. From the Main Menu, navigate to Maintenance
Schedule and select.
2. Navigate to Service Reset and select.
3. Choose which service(s) you would like to put back to
full interval (see Figure 9) and select.
Figure 9: Service Reset
System Alert Mode – Maintenance Schedule
System Alert Display
Fault Cause
Fault Remedy
Check Air Cleaner.
Scheduled maintenance check
Check/Replace air cleaner and reset
StatStation.
Replace Air Cleaner.
Total running hours reached
Replace air cleaner and reset
StatStation.
Check Engine Oil Fill Level.
Scheduled maintenance check
Check engine oil fill level and reset
StatStation.
Change Oil & Filter.
Total running hours reached
Replace oil and filter and reset
StatStation.
Check Spark Plugs.
Scheduled maintenance check
Check spark plugs and reset StatStation.
Change Spark Plugs.
Total running hours reached
Replace spark plugs and reset
StatStation.
All manuals and user guides at all-guides.com
