Not for
Reproduction
10 BRIGGSandSTRATTON.COM
How to Stop Your Electric Pressure
Washer
The electric pressure washer motor runs only when the
trigger is engaged. To stop the electric pressure washer
and turn off the motor:
1. Release spray gun trigger.
2. Press master ON/OFF switch to OFF (0) position.
NOTICE
Releasing the trigger will shut off the motor but
does not shut off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction, press
trigger lock button and squeeze trigger to relieve built
up pressure in the unit.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when motor
is stopped and water is disconnected, which could result
in serious injury.
• Keep high pressure hose connected to pump and
spray gun while system is pressurized.
• ALWAYS point spray gun in safe direction, squeeze
spray gun trigger to release high pressure, every time
you turn off pressure washer.
5. Disconnect GFCI plug from outlet and coil power cord
on bottom hook of accessory tray.
6. Wrap high pressure hose and store on top hook of
accessory tray.
7. Store red high pressure nozzle on end of nozzle
extension. Store spray gun, nozzle extension and 7-in-
1 nozzle on the accessory tray.
How to Use Nozzles
7-in-1 Nozzle
The 7-in-1 nozzle allows you to switch between seven
different spray pattern nozzles. Release trigger on spray
gun to engage safety lock before changing spray patterns.
The spray patterns vary as shown below.
1. Select desired spray pattern:
• Select Maximum 0° nozzle setting for stubborn
or hard to reach surface such as second story
surfaces, paint removal, oil stains, rust removal or
other stubborn substances (tar, gum, grease, wax,
etc.).
• Select General 15° nozzle setting for tougher
cleaning tasks. Ideal for removing grease and dirt
from hard surfaces. Also capable of stripping paint
when held at a 45° angle.
• Select Gentle 40° nozzle setting for gentle cleaning
of cars/trucks, boats, RV’s, patio furniture, lawn
equipment, etc.
• Select Fan Spray nozzle setting for optimal high
flow rinsing away of light dirt and debris.
• Select Fan Spray with Soap nozzle setting for
delicate surface cleaning of cars, trucks, childrens
play equipment, patio furniture, etc.
• Select Extended Reach nozzle setting for quick
high flow clean up and long reach cleaning of
second story siding and windows.
• Select Extended Reach with Soap nozzle setting to
propell soap to second story siding and windows.
2. Turn dial until desired spray pattern lines up with
arrow on 7-in-1 nozzle.
Red High Pressure Nozzle
The red high pressure nozzle gives you the most cleaning
power by producing the highest pressure.
Usage Tips
• For most effective cleaning, keep nozzle from 8 to
24 inches away from cleaning surface.
• If you get nozzle too close, especially using a high
pressure spray pattern nozzle, you may damage
surface being cleaned.
• Do Not get closer than 6 inches (15 cm) when
cleaning tires.
0˚
15˚
40˚
Maximum
General
Gentle
Fan Spray
Fan Spray
with Soap
Extended Reach Extended Reach
with Soap
High Pressure Mode
High Flow Mode