Briggs & Stratton 86262GS, Familiarization & Troubleshooting Manual

Page: 109 / 128

107
• Install the lock washers and nuts to the vibration mount
studs under the cradle frame arm
(Figure 4.45).
• Torque to specifications found in the appendix of this
guide.
Installing End Cover to Bearing Carrier.
The louvers on the end cover should be facing in towards
the generator as shown in Figure 4.46.
• Ensure that the louvers are up as shown.
• Place the tab at the top of the cover over the grommet.
• Install the cover with the screws you retained from
disassembly.
• Torque to specifications found in the torque chart in
the appendix of this guide.
• Reinstall spark plug into cylinder head.
• Install spark plug lead.
• Start and test unit.
Section 4 • Generator Assemblies
Portable Generator Familiarization & Troubleshooting Guide
Figure 4.46 — Installing End Cover
Figure 4.45 — Tighten Vibration Mounts