Briggs & Stratton 86262GS, Familiarization & Troubleshooting Manual

Page: 107 / 128

105
The back of the connector plug has raised numbers that
identify its specific compartments (Figure 4.38).
When you have installed the terminal connector into the
connector housing:
• Secure the power leads and connector housing to the
back of the power control panel (Figure 4.39).
Reinstall Generator Ground Wire
Remove any supporting blocks that might still be holding the
generator from resting in its cradle.
You should have retained two star washers and 1 wing nut
from disassembly.
• Install one star washer on the grounding lug.
• Then, the terminal lug for the grounding wire and the
other star washer.
Secure all of these with the “Wing nut” as shown in
Figure 4.40.
Section 4 • Generator Assemblies
Portable Generator Familiarization & Troubleshooting Guide
Figure 4.38 — Connector With Raised Numbers
Figure 4.39 — Connector Housing To Control Panel
Figure 4.40 — Grounding Connection
Raised Numbers
Star Washer
Star Washer
Raised Numbers