Briggs & Stratton 71 Piece Air Tool Kit, Operator'S Manual

Page: 12 / 44

10 BRIGGSandSTRATTON.COM
CAUTION Always use accessory fittings and
sockets designed for use with impact tools. Do
not use worn-out or hand-tool sockets.
NOTICE The impact tool should never be used
to set torque. Use a torque wrench to set the
torque.
To remove nuts, set the tool’s regulator to its
maximum setting by pushing in and turning the
knurled knob to position 4.
To install nuts, set the regulator to it’s minimum
(1) or medium (2 or 3) setting. Do not
over-tighten fasteners.
Forward and reverse directions are controlled by
a push button. Press the button fully forward for
clockwise socket rotation. Press the knob fully
backward for counter-clockwise socket rotation.
150mm Air Hammer
Description
This air hammer is designed for cutting through
rusted metal or bolts and for removing mortar
from cement blocks or bricks.
Air Hammer Operation
NOTICE This air hammer requires lubrication
BEFORE initial use and BEFORE and AFTER
each additional use throughout its life. Follow
the instructions in Air Motor Lubrication
described in Assembly to lubricate this tool.
CAUTION Inspect the tool before use to ensure
there are no loose components. Make sure
spring retainer and all air connections are
secure and for the absence of defects or other
conditions that may affect safe operation.
Before each use, drain water out of air
compressor tank and condensation from air
lines.
To load a chisel, remove the spring retainer from
the air hammer by rotating the spring
• When operating air hammer, always wear ANSI-
approved hearing protection.
• Always wear ANSI Z87.1 approved safety glasses with
side shields.
• Wear a full face shield if you are producing metal
splinters or working overhead.
• Wear an ANSI approved dust mask or respirator
when working around metal, wood, and chemical
dusts and mists.
W WA AR RN NIIN NG G
Air hammer operation causes loud
noises and flying debris.
Air hammer attachments can
disintegrate without warning while in
use, causing flying debris.