background image

Not for 

Reproduction

12 

BRIGGSandSTRATTON.com.au

Maintenance

Cleaning

Daily or before use, look around and underneath the 

generator for signs of oil or fuel leaks. Clean any accumulated 

debris. Keep area around muffler free from any debris.
  •  Use a soft bristle brush to loosen caked on dirt or oil.
  •  Use a damp cloth to wipe exterior surfaces clean.

NOTICE

   

Improper treatment of generator could damage 

it and shorten its life. Do not expose generator to excessive 

moisture, dust, dirt, or corrosive vapors. Do not insert any 

objects through cooling slots.

Engine Maintenance

Oil Recommendations

We recommend the use of Briggs & Stratton Warranty 

Certified oils for best performance. Other high-quality 

detergent oils are acceptable if classified for service SF, 

SG, SH, SJ or higher. Do not use special additives.
Outdoor temperatures determine the proper oil viscosity 

for the engine.  Use the chart to select the best viscosity for 

the outdoor temperature range expected.  Engines on most 

outdoor power equipment operate well with 5W30 Synthetic 

oil.  For equipment operated in hot temperatures, Vanguard® 

15W50 Synthetic oil provides the best protection.

*  Below 4°C (40°F) the use of SAE 30 will result in hard starting.
**  Above 27°C (80°F) the use of 10W30 may cause increased oil 

consumption. Check oil level more frequently.

Checking/Adding Engine Oil

Oil level should be checked prior to each use or at least 

every 8 hours of operation. Keep oil level maintained.
  1.  Make sure generator is on a level surface.
  2.  Loosen the two maintenance cover screws and 

remove the side maintenance cover.

  3.  Clean area around oil fill, remove oil fill cap and check 

oil level.

  4.  If needed, slowly pour oil into oil fill opening to the 

point of overflowing.

  5.  Replace and tighten oil fill cap.

NOTICE

   

Do not attempt to crank or start engine before 

it has been properly serviced with recommended oil. This 

could result in an engine failure.
  6.  Reinstall the side maintenance cover and hand  

tighten the cover screws.

 CAUTION   

Avoid prolonged or repeated skin contact with 

used motor oil. Used motor oil has been shown to cause 

skin cancer in certain laboratory animals. Thoroughly wash 

exposed areas with soap and water.

  KEEP OUT OF REACH OF CHILDREN. DON’T 

POLLUTE. CONSERVE RESOURCES. RETURN 

USED OIL TO COLLECTION CENTERS.

Changing Engine Oil

If you are using your generator under extremely dirty or 

dusty conditions, or in extremely hot weather, change the 

oil more often.

Change the oil while the engine is still warm from running, 

as follows:
  1.  Make sure unit is on a level surface.
  2.  Drain fuel tank by running generator until fuel tank is 

empty.

  3.  Remove cover over the oil fill area.
  4.  Clean area around oil fill and remove oil fill cap.
  5.  Tip your generator to drain oil from oil fill into a 

suitable container making sure you tip your unit toward 

the oil filler neck. When crankcase is empty, return 

generator to upright position.

  6.  Using an oil funnel, slowly pour recommended oil 

(about 0.4 l (13.5 oz.)) into oil fill opening. Checking oil 

level frequently, fill to point of overflowing.

NOTICE 

  Pause to permit oil to settle. DO NOT overfill.

  7.  Replace and tighten oil fill cap.

  8.  Wipe up any spilled oil.
  9.  Replace cover over oil fill area.

www.caravansplus.com.au

Summary of Contents for 030802

















Reviews: