Brigantia 57-DVRS50, User'S Installation, Operation And Maintenance Manual

Page: 14 / 45

57-DVRS50
14
Installation Instructions Cont.
VENTING
Clearance to combustibles
The following clearances must be maintained around the vent pipe:
Vertical runs:
1”
Horizontal runs: 2” on top, 1” sides and bottom
IMPORTANT: This appliance venting system is a sealed system (DV), which means that all combustion
air is supplied from outdoors and the combustion products are exhausted to the outdoors.
Note : Only venting systems listed in this manual may be used with the model 57-DVRS50
Planning your vent installation
This type of direct vent system may terminate in one of two ways: vertical termination using a vent cap, or
horizontally using a wall termination. There are limitations to the vertical and/or horizontal lengths (see
page 18 for venting chart).
When calculating the length of the vent pipe from the outlet of the appliance to termination, allowing for
ceiling thickness, the vertical rise in the attic or second story and sufficient vertical height above the roof.
Fire stops are required at each floor level the vent passes through.
The following vent systems are certified for use with the model 57-DVRS50
If for any reason the vent pipe is disconnected it must be correctly resealed
Fig 14-A
Manufacturer Vertical Termination Adapter
Archgard
999-DV-8HTCL (Direct connect to unit)
999-DV-8HTCLT ( Flex connect to unit)
N/A
Dura Vent ??? - Co-Axial Cap (requires adapter)
??? - Co-Axial High Wind (requires adapter)
58DVA-MG
ICC/Excel ?? - Co-Axial (requires adapter)
???- Co-Axial (requires adapter)
Ameri-vent
DVC - Co-Axial Cap (requires adapter)
Selkirk
Direct Temp DV Venting 5DT-AA Series
2-ply Aluminum
5” x 8” 2-ply Listed Aluminum Flexible pipe
A T T E N T I O N
NO OTHER VENTING SYSTEM OR COMPONENTS MAY BE USED. Follow manufacturer instructions
for installation of termination.
The listed chimney vent systems use a twist lock connection. Assemble the vent system using the de-
sired combination of sections and elbows for your installation. Make sure you fully insert and twist the
mating sections all the way to make a solid connection.
Install as per manufactures instructions