At the very top, a graphic is displayed representing the front panel of the probe, indicating the status of
the different inputs.
Below this display, the following parameters are shown:
NTP/timesync
(Bulb):
The NTP/timesync bulb indicates whether the VB440 clock is locked to an external
time reference signal. Green indicates that the VB440 is locked to an external reference
whereas grey indicates that the VB440 runs in unlocked mode.
Updated:
The time since the last time synchronization update.
Freq offset:
Indicates the measured frequency offset for the system clock.
Timezone:
The time zone as selected by the operator in the
Setup — Params
view.
Time:
The current local time (configured in the
Setup — Params
or
Setup — Time
view).
Counters and alarms
Clear all:
Click the
Clear all
button to reset all counters, graphs and alarms. All VB440
measurement and alarm history is cleared. Note that it is not possible to undo this
operation.
Last cleared:
The time the
Clear all
button was last clicked. If no time is indicated the counters
have not been cleared since VB440 startup/reboot time.
Probe
Name:
The VB440 name as defined by the operator in the
Setup — Params
view.
Location:
The VB440 location as defined by the operator in the
Setup — Params
view.
Access:
The access rights of the current user. Access rights are either full access or read only
access, and are defined by the operator in the
Setup — Security
view.
Traffic
RX data:
The total bitrate of received data traffic
Monitored data:
The total bitrate of multicasts and unicasts monitored (analyzed) by the probe
At the very bottom of the Summary page, an overview of the Ethernet network interfaces on the VB440
are displayed.
Network interfaces
Interface:
The ID of the selected network interface.
Link:
Indicates whether the interface is connected.
Speed:
Shows the current bitrate for the interface.
Description:
Provides a human-readable description of the interface, if available.
IPv4 address:
Lists the IPv4 address and netmask of the network interface, if set.
IPv6 address:
Lists the IPv6 address and netmask of the network interface, if set.
VB440 Studio Probe User’s Manual v6.0
© Bridge Technologies Co AS
47
