7
CLEANING THE FILTER
✎
✎
✎
✎
✎
NOTE
To prevent damage to the filter,
avoid pressing the mesh.
!
!
!
!
!
WARNING
Do not operate this kettle without the
filter fitted.
Removing/Refitting the Filter
Important:
Before removing or
refitting the filter, switch the kettle
off. Unplug the power base, empty
the kettle and allow to cool
completely.
To Remove the Filter
•
Ensure the kettle has cooled
fully and is empty.
•
Paying close attention to how
the filter is installed, pull
upwards gently on the top edge
of the filter to unclip.
•
Lift the filter vertically out of the
kettle.
To Clean the Filter
•
Rinse the filter under a tap
whilst brushing with a soft
brush. In hard water areas it
may be necessary to descale
with a descaling agent.
Use a proprietary descaler,
following the manufacturer’s
instructions carefully.
To Refit the Filter
•
Make sure that your hands are
clean and free from soap,
cream or anything which might
taint the water.
•
Place kettle on the worktop
and locate the filter into the
spout as follows:
Align the filter with the three
locating clips, push down to
clip into position.
