Breville VIN170, Instruction Booklet

Page: 14 / 24

14
anti-calc cartridge
Anti-calc system
The anti-calc cartridge should be replaced when the anti-calc cartridge indicator light
flashes. If a new cartridge is not immediately available you may continue ironing using
distilled water in place of tap water.
IMPORTANT : When the anti-calc cartridge requires renewal, do NOT continue to use
your steam generator with tap water as this may cause damage. NEVER attempt to use
your steam generator without the anti-calc cartridge in place.
Replacing the anti-calc cartridge
1. Press the water tank release button.
2. Remove the water tank.
3. Lift up the ring on the cartridge and use it to pull the cartridge straight upwards out of
its compartment underneath the water tank.
A little water may be left behind in the cartridge compartment when you remove the
old anti-calc cartridge. Use a clean cloth or kitchen paper to dry out the compartment
before you refit the new anti-calc cartridge.
4. Fit the new anti-calc cartridge pressing it firmly down into place.
5. Refit the water tank.
Resetting the anti-calc system after replacing the cartridge
1. While the anti-calc cartridge indicator light is flashing, press and hold the on/off
button for approximately 5 seconds.
2. This will reset the anti-calc system and the anti-calc cartridge indicator light will stop
flashing and go out.