Operating your Breville Emporia Cordfree Kettle
Before first use
Remove any promotional material attached to your
kettle. It is recommended that before the first use,
the kettle is filled to the maximum level, boiled and
the water discarded. Your kettle will only operate
when positioned on the power base with the ON/OFF
switch in the ‘ON’ position. The kettle will
automatically switch ‘OFF’ once the water has boiled.
Operation of your kettle
1. To fill the kettle, remove it from the power base
and open the lid by pulling up. Fill with the
desired amount of water up to the maximum
mark on the water window.
2. Ensure that the lid is locked firmly in place.
Place the kettle firmly onto the power base.
Plug the power cord into 230/240V power point
and switch ‘ON’.
3. Press the ON/OFF switch to the ‘ON’ position.
The heating light will illuminate.
4. The kettle will automatically switch ‘OFF’ once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to hold
the kettle level especially when filled to the
maximum level. To re-boil it may be necessary to
wait for a few seconds to allow the control to
reset. The kettle may be stored on its power base
when not in use. The power point should be
switched off and the appliance plug unplugged
from the power point when not in use.
Always fill the kettle between the minimum
(MIN) and the maximum (MAX) marks on the
exterior of the kettle. Too little water will result
in the kettle switching ‘OFF’ before the water
has boiled. Filling above the maximum mark on
the exterior of the kettle may result in boiling
water splashing out from the kettle.
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald. Do
not pour the water too quickly.
Note
6
THIS APPLIANCE IS DESIGNED FOR THE BOILING OF DRINKING QUALITY WATER ONLY, NEVER
USE IT TO HEAT OR BOIL ANY OTHER LIQUIDS OR FOODSTUFFS. THE LID SHOULD ALWAYS BE
FIRMLY IN PLACE AND LOCKED CLOSED BEFORE USE.
