11
10
TROUBLESHOOTING AND SUPPORT
For troubleshooting and FAQs visit
www.breville.co.uk
.
Problem
Cause
Solution
The air purifier is not working.
The appliance is not plugged in.
Check if unit is properly
plugged in and outlet is
working.
The appliance is not switched on.
Make sure unit is turned
ON.
The filters are not properly
installed.
Make sure filters are
properly installed.
The panel cover is not fully
assembled.
Check that the back
panel cover is correctly
assembled. Align and mount
the cover into the base
of the appliance first, and
then push the top of the
panel against the appliance
(Figure 6).
The air flow has decreased.
The air intake grille and filtered air
outlet may be obstructed.
Turn OFF and unplug the
appliance. Remove any
obstructions blocking the air
intake grille and filtered air
outlet.
The filter is nearing the end of its
useful product life.
Check the condition of
the filters and replace if
necessary.
Pre-installed filters are covered by
a protective plastic packaging.
Check filters to remove any
plastic packaging and re-
install the filters.
The air purifier is making a loud
noise.
Pre-installed filters are covered by
a protective plastic packaging.
Check filters to remove any
plastic packaging and re-
install the filters.
The ioniser function is operating.
This is normal and occurs
when a small buildup of ions
is discharged.
ELECTRICAL SAFETY
AFTER SALES SERVICE AND REPLACEMENT PARTS
In the case the appliance does not operate but is under warranty, return the product to the
place it was purchased for a replacement. Please be aware that a valid form of proof of
purchase will be required. For additional support, please contact our Consumer Service
Department at:
0800 028 7154.
Alternatively, e-mail: [email protected].
WASTE DISPOSAL
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. E-mail us at [email protected] for further recycling and
WEEE information.
If the plug is not suitable for the socket outlets in your
home, it can be removed and replaced by a plug of
the correct type.
If the fuse in a moulded plug needs to be changed,
the fuse cover must be refitted. The appliance must
not be used without the fuse cover fitted.
If the plug fuse requires replacement, a fuse of the
same rating as that fitted by the manufacturer must be
used. In order to prevent a hazard do not fit a fuse of
a lower or higher rating.
If the terminals in the plug are not marked or if you
are unsure about the installation of the plug please
contact a qualified electrician.
Do Not Connect
Mains Wires Here
Blue
(Neutral)
Brown
(Live)
Fuse
Ensure that the outer sheath of
the cable is firmly held by the cord grip
Plug should be ASTA approved to BS1363
Fuse should be ASTA approved to BS1362
3A
