9
8
OPERATING INSTRUCTIONS
1. Place the unit on a dry, stable, and firm surface. Make sure not to block the top air
outlet vent and air intake grille.
2. Plug the unit into a power supply socket.
3. Tap the power button to turn the unit ON.
4. When the appliance is starting up, the digital displays on the screen and the air quality
LED indicator will initially illuminate red and then change to yellow.
5. After measuring the particulate matter in the air for approximately 20 seconds, the
appliance will display the particle count and air quality colour. The appliance will
operate in auto mode by default and change the fan speed accordingly.
6. To select a desired fan speed, tap the fan button to cycle through the speeds auto,
4 (high), 3, 2, 1 (low) until the desired speed setting is illuminated. Note: Auto mode
will automatically adjust the fan speed setting when a change in the room’s air quality
is detected.
7. To set the timer for 2, 4 or 8 hours, tap the timer button until the desired setting is
illuminated. When the set time has elapsed, the appliance will automatically switch off.
To deactivate the timer, tap the timer button repeatedly until the timer setting lights
are turned off.
8. To turn night mode ON, tap the button once until the white LED light next to the
button is illuminated. Tap the button again to turn night mode OFF.
Note: Night mode will maintain your previous fan speed setting and turn the display
lights OFF.
9. Important:
Always turn OFF and unplug the unit when not in use.
CARE AND MAINTENANCE
• Before cleaning the air purifier, always turn OFF and unplug the unit.
• Clean the exterior surface with a clean, damp cloth.
• The top air outlet vent can be cleaned of dust with a small, soft brush.
• If you would like to clean the inside of your filter compartment, ONLY use a dry, soft
cloth to wipe it down.
WARNING:
Do not allow moisture to come into contact with the main housing of the air
purifier. NEVER use detergents, glass cleaner, furniture polish, paint thinner, or other
household solvents to clean any part of the appliance.
HOW TO REPLACE THE TRUE HEPA FILTER
It is recommended to replace the 3-in-1 True HEPA filters every 12 months depending on
usage.
1. The filter replacement indicator light will illuminate red when it is time to replace the
filter.
2. Turn the unit OFF and unplug the air purifier.
3. Pull the top part of the back panel cover towards you to release it from the appliance
(Figure 1).
4. Remove and discard the top True HEPA filters from the appliance (Figure 2).
5. Once removed the filter separation plate will spring up to give access to the lower filter.
The plate can be rotated upwards for better access (Figure 3).
6. Remove and discard the lower True HEPA filter (Figure 4).
7. Insert two new True HEPA filters. Insert the bottom filter first, then insert the top filter
(Figure 5).
8. To reattach the back panel cover, align and mount the cover into the base of the
appliance first, and then push the top of the panel against the appliance (Figure 6).
9. Plug the unit and turn the power ON.
10. To reset the filter status on the air purifier, press and hold the night mode button for
3 seconds. The air purifier will beep once. The filter replacement indicator light will
flash and beep 3 times and then turn off. The air purifier is ready for use.
(See section ‘Installing the True HEPA filters’ for Figures 1-6).
Warning:
Only use the original Breville filter model BAPF70 specially intended for this
appliance. Do not use any other filters.
Information on where to purchase replacement filters can be found on our website at
www.breville.co.uk.
