13
Operation
OPERATING YOUR
AQUASTATION PURIFIER
1. Ensure the upper pre-filtered water tank is
assembled inside the lower filtered water
tank, and that the water filter cartridge is
correctly fitted into position.
2. Plug into a 230/240V power outlet.
3. Remove the water tanks from the purifier
and fill the pre-filtered water tank with cold
tap water to the MAX level. Alternatively,
pour water into the tanks using a water jug.
Never fill past the MAX level.
4. Once water has filtered into the filtered
water tank, the pre-filtered water tank can
be topped up until both water tanks are
filled to the MAX level.
5. With the now filled water tanks assembled
to the purifier base, place a cup of choice
onto the drip tray, or alternatively, remove
the drip tray to accommodate large glasses.
6. Press the START/STOP button once to
dispense water. Press START/STOP again
to stop water dispensing.
NOTE
If the START/STOP button is not pressed a
second time to stop dispensing water, the unit
will automatically stop dispensing water after
60 seconds.
NOTE
Always ensure the water tanks are filled to the
MAX level for optimum flow of water from
the spout. Never allow the water tanks to fall
below the MIN level. The water sensor will
automatically stop dispensing and the Fill
Tank indicator will illuminate when the water
level becomes too low.
Regularly check and discard any water that
might accumulate in the drip tray.
TURNING OFF THE MACHINE
Turn off at the power outlet.
NOTE
Discard any filtered water that has been left
sitting for several days or more. This will
ensure you have cleaner, great-tasting water.
If your filter has been unused for a long period
of time, it is recommended to resoak the filter
for 10 minutes before use and clean the water
tanks as per the cleaning instructions found in
this book.
Ambient water temperature will vary. The
temperature dispensed will be influenced by
the external factors surrounding the purifier
itself. An increase in the air temperature will
cause water tank temperature to increase as
well.
If the water temperature in the tank becomes
too warm, discard and replace with cold tap
water. Water temperature in the tank should
not be dispensed if above 40°C.
