10
Assembly
BEFORE FIRST USE
•
Remove and safely discard any packaging
material or promotional labels attached
to your water purifier and filter. Check for
any missing or damaged parts as per the
components list.
•
Remove the Actve360™ 4-Stage filter from
the water tank and set aside.
•
Do not wash the filter or insert into the
upper water tank until ‘Flushing the Breville
AquaStation’ and ‘Preparing the 4-Stage
Filter’ instructions are completed as found in
this book.
•
Place the water purifier on a dry, flat level
surface.
•
Wash the water tank lid, upper (pre-filtered)
water tank, lower (filtered) water tank in warm
soapy water with a soft, non-abrasive cloth.
Rinse and dry thoroughly with a clean, soft,
lint-free cloth and return to the purifier.
•
Assemble the water tank back on to the
power base.
•
Plug the power plug into a 230/240V power
outlet and turn on the power outlet.
IMPORTANT
When moving the water purifier, always lift
from the base using two hands and set down
gently on a flat and level surface.
FLUSHING THE BREVILLE
AQUASTATION
It is important to flush and rinse the dispensing
system before using the water purifier for the
first time. Before first use, it is recommended
to carry out the below steps without the
Activ360™ Water Filter in place.
1. Fit only the larger lower (filtered) water tank
into place on the base of the purifier with
the lid removed.
2. Fill the lower tank with cold tap water to the
MAX level. Never fill past the MAX level.
3. Place a 1L container under the dispensing
spout.
4. Press the START/STOP button once to
start dispensing water until the container
is full, then press the START/STOP
button again to stop dispensing. Discard the
collected water.
5. Repeat steps 3-5 until all the water in the
lower tank has been dispensed. The water
purifier will stop dispensing automatically
when the water level is too low or
automatically after 60 seconds.
6. Proceed to the next step, ‘Preparing the
Activ360™ Filter'.
PREPARING THE ACTIV360™ FILTER
Flushing the filter is required every time you
insert a new filter cartridge.
10m
1L
3x
MAX
MIN
MAX
MIN
90d
SHAKE FILTER
NEW FILTER
3s
The filter replacement alert will notify after 90
days or 200L of water filtered that it is time to
replace the filter cartridge.
10m
1L
3x
MAX
MIN
MAX
MIN
90d
SHAKE FILTER
NEW FILTER
3s
3 beeps will sound and the water droplet light
will flash continuously in red.
