Bresser Tendence FSX, Instruction Manual

Page: 9 / 100

9 / 100
7 Transmission symbol (ra-
dio-controlled clock CET)
8 Alarm (AL1 or AL2)
9 Air pressure (mb/hPa or
inHg)
10 Moon phase
11 Bar chart for air pressure
history
12 Weather trend (72 hours)
13 Humidity outdoors 14 Humidity indoors
15 Battery status 16 Temperature (indoor)
17 Temperature (outdoor) 18 Channel info (sensors)
19 Sensor signal status 20 Weather trend (48 hours)
21 Weather trend (24 hours) 22 Singles values for air pres-
sure history (up to 24 hours)
6 Before commissioning
NOTICE
Avoid connection faults!
In order to avoid connection problems between the devices,
the following points must be observed during commission-
ing.
1. Place the base unit (receiver) and sensor (transmitter)
as close together as possible.
2. Connect the power supply to the base unit and wait un-
til the indoor temperature is displayed.
3. Establish power supply for the sensor.
4. Set up/operate the base unit and sensor within the ef-
fective transmission range.
5. Make sure that the base unit and the radio sensor are
set to the same channel.
When changing the batteries, always remove the batteries
from both the base unit and the sensor and reinsert them in
the correct order so that the radio link can be re-estab-
lished. If one of the two devices is operated via a mains
power connection, the power connection must also be