Bresser Tendence FSX, Instruction Manual

Page: 13 / 100

13 / 100
5. Press ALARM button to confirm and continue to the
next setting.
6. Settings order: hours > minutes > ice alert on/off
NOTICE! If ice alert is enabled (on), the alarm will sound 30
minutes before the set alarm time if the temperature is -3°
or below.
7. Finally press the ALARM button to save the settings and
exit the setting mode. Alarm will be activated automat-
ically. The symbol will be displayed.
8. In normal display mode, press the ALARM button sev-
eral times to enable alarm time AL1, AL2 or both. If the
alarm is enabled, the corresponding symbol will be dis-
played ( 1, 2 or 1 2).
12 Snooze function
1. When the alarm sounds press the SNOOZE/LIGHT but-
ton to activate the snooze function. The alarm will
sound again in 5 minutes.
2. Press ALARM button when the alarm sounds to inter-
rupt the alarm until the alarm time will be reached
again.
3. The alarm will be turned off automatically if no button
is pressed within 2 minutes.
13 Receiving measurements automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press 12/24 button for approx. 3 seconds to initate recep-
tion of measurements again.