15
10. RAINBOW button
11. TUNE button
12. Focusing wheel
13. MAX/MIN button
14. RCC button
15. °C/°F button
16. (16.) RESET knob
17. OFF/LO/HI slide switch
18. DC jack
19. Battery compartment
Remote sensor
(Fig. 3)
20. Red LED indicator
21. Mounting base
22. RESET button
23. CH Channel slide switch
24. Battery compartment
BEFORE YOU START
IMPORTANT!
1. Insert batteries for main unit before doing so for the remote units.
2. Place the main unit as close as possible to the remote unit.
3. Position the remote unit and main unit within the effective
transmission range.
When changing batteries always change batteries in the main
unit as well as all remote units and replace them in the correct
order, so the remote connection can be re-established.
If batteries are exchanged in only one of the devices (i.e.
the remote sensor) the signal can’t be received or can’t be
received correctly.
Note, that the effective range is vastly affected by building
materials and position of the main and remote units. Due to
external influences (various RC devices and other sources of
interference), the maximum distance can be greatly reduced.
In such cases we suggest to position the main unit and the
remote sensor at other places. Sometimes all it takes is a
relocation of one of these components of a few inches!
Though the remote unit is weather proof, it should be placed
away from direct sunlight, rain or snow.
POWER SUPPLY
Main station
1. Put the DC power plug (Fig. 1, C) in the DC jack (Fig. 2, 18).
2. Push the RESET knob to initialize the automatic time signal
and remote sensor signal seanning.
3. Open the battery compartment covering carefully with a
coin (turn to arrow direction OPEN).
4. Insert 1 button cell (Typ CR2032, 3V) according to the
DE
GB
FR
IT
ES
Gar
antie / W
ar
ranty
