10 / 32
1. Charge the rechargeable battery* completely.
2. Insert the battery into the battery socket at the backside of the housing.
CAUTION! Before switching on the device, make sure that only one voltage source is used
(power adapter or battery)!
3. Move voltage toggle switch to position 'BATTERY' to operate the device by battery.
4. Press ON/OFF button for approx. 2 seconds to turn on the light.
5. Press ON/OFF button again for approx. 2 seconds to turn off the light.
*not included
9 Changing the lighting angle
1. Carefully loosen the locking knobs on both sides of the U-mount.
2. Move the light to the desired angle.
3. Hand-tighten the locking knobs again.
DANGER! Allow the housing surface to cool down before touching it! Touching hot components
can cause serious burns.
WARNING! Hold the light when the locking knobs have been loosened to avoid damage to the
panel!
10 Connection with an lighting console (DMX-RJ11)
(optional)
One or more LED lights can be controlled centrally when connecting them with a RJ11 compatible
lighting console* through suitable connection cables*.
1. Insert the RJ11 modular plug of the connection cable* into the corresponding socket on the lighting
console* and into the socket of the LED light.
2. Press the control selection knob to enable control via DMX lighting console. The DMX function
lamp lights up.
NOTICE! In DMX control mode, the LED light can be controlled only through the console.
3. For the manual control or remote control*, press the control selection knob again. The 2.4G func-
tion light will light up.
*not included
11 Overheating protection
If the temperature inside the device rises above the safety limit, all functions will be disabled automat-
ically. Only the fan will work to ensure the device is cooling down. Once the temperature has dropped
under the limit, all functions will be activated again.
12 Remote control (optional)
The device can be controlled with a suitable 2.4GHz remote control* over the built-in receiver. When
using the same channel, different devices can be operated at the same time through the rermote con-
trol*.
To control the device through a remote control, proceed as follows:
1. Turn on the device(s).
2. Set the desired receiving channel to all lights being controlled.
3. Set the channel also for the remote control.
