94
10.3
RESET AND FACTORY RESET
To reset the console and start again, press
[ RESET ]
key once. To restore to factory settings follow
the step in
section 4.9.8
table (
Factory reset).
11. WIRELESS 7-IN-1 MULTISENSOR MAINTENANCE
REPLACE THE WIND VANE
Unscrew and remove the wind
vane for replacement
REPLACE THE WIND CUP
1. Unscrew and remove the
top cap
2. Remove the wind cup for
replacement
CLEANING THE RAIN
COLLECTOR
1. Rotate the rain collector by turning
it 30°anti-clockwise.
2. Gently remove the rain collector.
3. Clean and remove any debris or
insects.
4. Install the collector when it is clean
and fully dried.
CLEANING THE UV SENSOR
AND CALIBRATION
• For precision UV measurement,
gentle clean the UV sensor cover
lens with damp micro-fiber cloth.
• Over time, the UV sensor will
naturally degrade. The UV sensor
can be calibrated with a utility
grade UV meter, please refer to
Calibration section in previous page
for about the UV sensor calibration.
CLEANING HYGRO-THERMO
SENSOR
1. Remove the 2 screws at the
bottom of the radiation shield.
2. Gently pull out the shield.
3. Carefully remove any dirt or
insects on the sensor and
ventilation fan (do not let the
sensors inside get wet).
4. Clean the shield with water to
remove any dirt or insects.
5. Install all the parts back when
they are clean and fully dried.
12. TROUBLESHOOT
Problems
Solution
7-in-1 wireless sensor
is intermittent or no
connection
1. Make sure the sensor is within the transmission range
2. If it still not work, reset the sensor and resynchronize with console.
Wireless sensor is
intermittent or no
connection
1. Make sure the sensor is within the transmission range
2. Make sure the channel displayed match to the channel selection on
sensor
3. If it still not work, reset the sensor and resynchronize with console.
No WI-FI connection
1. Check for WI-FI symbol on the display, it should be always on.
2. Make sure you connect to 2.4G band but not 5G band of your WI-FI
router.
Display screen not working
1. Check that the power adapter is plugged into the console and an
electrical outlet.
2. Reset the console by pressing the “RESET” button that located on
the back of the console.
Data not reporting
to ProWeatherLive,
Wunderground.com or
weathercloud.net
1. Ensure your Station ID and Station Key are correct.
2. Ensure the date and time is correct on the console. If incorrect, you
may be reporting old data, not real time data.
3. Ensure your time zone is set properly. If incorrect, you may be
reporting old data, not real time data.
Summary of Contents for 7003500
Page 98: ......
