brent THE GRAIN TRAIN 740, Operator'S Manual/Parts Catalog

Page: 9 / 43

- MODEL 740 -
Page 9
ADJUSTABLE CHUTE
220937
Your grain wagon is equipped with an adjustable unloading chute-height feature. The
adjustment bolt is located under the door area of the grain wagon. When the bolt is turned
in (clockwise), the chute unload height decreases. When the bolt is turned out (counter-
clockwise), the chute height is raised.
The right and left side boards and center bracket are pre-assembled. An end board (front or rear)
is banded to the assembly with foam protection. The banded assemblies are stored on the front
and rear angle brackets on each side of the box. Three bolts hold each assembly in place. The
center bracket is bolted to the brace tube angle bracket (see inset).
IMPORTANT: AT LEAST TWO INDIVIDUALS ARE REQUIRED TO ERECT THE SIDE BOARDS.
To erect the side boards, remove three fasteners (each side) and cut the banding. Turn front and
rear boards into position and install fasteners but do not tighten. Tilt side assemblies into position
and install fasteners. Install the angle braces and cross brace if applicable. The fasteners
supplied are 3/8 x 3/4 flange screws and flange nuts. NOTE: Have a longer capscrew on hand if
required for seating the boards initially. After all boards are in position, tighten fasteners.
SIDE BOARDS
220943
•03-13-98
SERVICE