- MODEL 740 -
Page 31
•03-13-98
SERVICE
FENDER INSTALLATION
NOTE: All capscrews and nuts which tighten
directly against the plastic fenders
must have a flatwasher to provide
adequate surface bearing.
Do not tighten fasteners during
assembly. After all fenders are
attached, visually align fenders with
tires and tighten all fasteners.
REAR FENDERS
1.
Assemble mud flaps and bottom arms (RH & LH) to rear fenders as shown with
3/8 x 2 capscrews, flatwasher, lockwasher and nuts.
2.
Bolt rear top arms to frame with 1/2 x 1 1/2 capscrews and locknuts.
3.
Position rear fenders over top arms and secure with 3/8 x 1 1 /2 capscrews,
flatwashers and nuts.
FRONT FENDERS
4.
Bolt front top arms to frame with 1/2 x 1 1/2 capscrews and locknuts.
5.
Mount tubes to frame brackets with U-bolts and 3/8 locknuts.
6.
Position front fenders over top arms and secure with 3/8 x 1 1 /2 capscrews,
flatwashers and locknuts.
7.
Bolt fenders to tubes with 3/8 x 1 capscrews, flatwashers and locknuts in top
holes.
8.
Assemble mud flaps and back plates
to fenders with 3/8 x 1 capscrews,
flatwashers and locknuts in bottom
holes.
Visually align fenders from front or rear and
tighten all fasteners.
Align edge of 12" x 26" plastic laminate with
rear edge of hopper (behind chute) and apply.
Trim laminate as required for hopper profile.
220921C
220921D
Summary of Contents for THE GRAIN TRAIN 740
