Brent 1082/882
— Maintenance
4-15
PTO Shaft and Clutch
(continued)
Coupling the PTO drive shaft (Figs. E1 - E2)
Clean and grease the PTO and implement input connection (IIC)
AS-Lock
1. Pull locking collar and simultaneously push
PTO drive shaft onto PTO shaft until the lock-
ing device engages.
Push-Pull Lock
2. Pull locking collar and simultaneously push
PTO drive shaft onto PTO shaft until the lock-
ing device engages.
• CHECK TO INSURE ALL THE LOCKS ARE SECURELY ENGAGED BEFORE STARTING
WORK WITH THE PTO DRIVESHAFT.
Length Adjustment (Figs. F1 - F4)
NOTE: Maximum operating length LB. (Refer to “Verify Telescoping PTO Shaft Length” for
LB length.)
1. To adjust length, hold the half-shafts next to
each other in the shortest working position and
mark them.
2. Shorten inner and outer guard tubes equally.
3. Shorten inner and outer sliding profi les by the
same length as the guard tubes.
4. Round off all sharp edges and remove burrs.
Grease sliding profi les.
• CHECK THE LENGTH OF THE TELESCOPING MEMBERS TO INSURE THE DRIVELINE
WILL NOT BOTTOM OUT OR SEPARATE WHEN TURNING AND/OR GOING OVER ROUGH
TERRAIN.
E1
E2
F1
F2
F4
F3
(July 2014)
