Bremont ALT1-P2, Technical Notes, Page: 5 / 43

ALT1-P2
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. With the chronograph you can measure up to 12 hours in
hours, seconds and minutes. The mechanical movement with automatic
winding has a free-swinging rotor that keeps the mainspring wound via the
motion of your wrist. The movement in your ALT1-P2 has 27 jewels, runs at
28,800 bph and has a 42-hour power reserve once fully wound. The watch
is water resistant to 100m (10ATM) and the dial is protected by a dual anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WATCH
Your ALT1-P2 can be wound from crown position I by rotating the crown
in a clockwise motion. The movement will automatically start with just a
few revolutions of the rotor, however it is better to wind the movement
fully with 30-40 revolutions of the crown. By doing this you will achieve
maximum accuracy and have a power reserve of 42-hours, even when the
watch is not on your wrist.
SETTING THE dATE
Use the watch tool provided to press the rapid date change button
positioned at 10 o’clock to change the date.
SETTING THE TIME
Pull the crown out to position II, this will stop the movement, you can
now position the minute hand exactly. To start the second hand, push the
crown back to position I. When setting the time, it is worth noting that
the date change always takes place at mid-night (00:00). If this change has
already taken place at 12:00 noon, you must move the hands forward by 12
hours. Ensure that the crown is pushed back in after setting the watch