Breitling EXOSPACE B55, Manual

Page: 15 / 42

27 26
7. CONFIGURING THE wATCH (
SETTING
)
In the
SETTING
mode, the following adjustments can be made (all these settings are
memorized by the watch and therefore available even in the event of the battery
being completely flat):
1.
SyNCHRo
: synchronization of the analog display with the digital display.
2.
TILT
: lighting goes on automatically (and possibly the LCD) depending on the
position of the wrist (positioned around 30° to horizontal), but for a maximum
of 30 seconds, unless in the setting mode (
SETTING
).
3.
LIGHT
: setting the duration for the lighting to be switched on when the crown
is pressed.
4.
DISPLAy
: choice of digital LCD behavior – readable all the time even without
lighting or readable only with lighting.
5.
NIGHT MoDE
: Option of reducing the light intensity to a minimum and disabling
the
TILT
mode as well as notifications between 24:00 and 06:00. On the one
hand, this function makes it possible to reduce consumption and on the other,
to avoid the lighting being too bright in the dark.
6.
ToNE
: audible confirmations connected to pushpieces, with or without hourly
time signal or signal for full timekeeping hours.
7.
HANDPRK
: exit parking the hands mode after 5 minutes or simply with a double
press on the crown.
• If necessary, adjust the minutes in 15-minute increments and confirm by pressing
P2; the seconds flash (
SECoND
appears on the upper screen).
• Adjust the seconds (which will automatically be adjusted in the
TIME 2
and
UTC
)
and confirm by pressing P2.
• Press the crown back to neutral position 1.
N.B.: When in setting mode (
SETTIME
), pressing P1 will restart the seconds counter
from 0. The seconds counter only stops when the seconds are manually modified.
In this case, it restarts when exiting setting (putting the crown back to neutral
position 1). The seconds are automatically synchronized on the
UTC
and
TIME 2
timezones.
In
TIME
mode, pressing P1 makes it possible to go into
DATE
mode and display the
date according to different formats (see chapter 8). A long press on P1 puts the
display directly back to
TIME
.
In
TIME
mode, a long press on P2 allows to choose between either the 12-hour (
AM
or
PM
indicator) or the 24-hour display. The change also happens automatically for
the
TIME 2
zone and the seven alarms.