Rev 06131
5
Brehon Agrisystems Inc. is not responsible or liable for indirect, special, or consequential damages arising out of or in
connection with the use or performance of the product or other damage with respect to any economic loss, loss of
property, loss of revenue or profit, or costs of removal, installation, or reinstallation.
INSTALLATION INSTRUCTIONS
Connecting Power to Receiver:
Using sufficiently heavy gage wire, (not included), c12vdc and Ground wires to the wire
from the Electric Cylinder marked
POWER IN
using the crimp connectors supplied. The
polarity
must
be correct as follows:
+12v
on the
BLUE
wire
, and
GROUND
on the
BROWN
wire. Power may be supplied from the fused side of the ACCessories on the ignition
switch so that the Receiver is only powered while the vehicle ignition key is on or alternatively,
connected using an inline fuse directly to battery power. When the Power ON/Off switch on the
bottom of the Receiver is turned on the Red LED indicator light should be ON indicating normal
operation.
Electric Cylinder Installation:
Before mounting the Electric Cylinder on the end gate, determine the correct location for installing
the mounting tabs by extending and retracting the cylinder to ensure required stroke. This can be
accomplished once power is supplied to the Receiver by pressing the ENDGATE manual switches
on the Receiver.
Ensure the grain chute operates freely. Position the mounting tabs such that when the grain chute is
fully open the cylinder is not quite fully retracted. Then check to ensure that the distance to fully
close does not exceed the electric cylinder stroke length and that the electric cylinder can be
mounted free of any obstacles.
Weld or drill/bolt the mount tabs in position on the vertical center-line of the grain chute and box
end panel at the desired positions.
Attach the cylinder main body to the top mount tab using the bolt and locknut supplied. Attach the
cylinder piston to the moveable grain chute with the snap pin supplied. Route the electrical wire
and connect using the insulated crimp terminals supplied. Secure all wires using the cable ties
provided.
NOTE:
The existing lift handle on the endgate need not be removed, however, it must not be able
to lock in any position. This could cause the electric cylinder to stall resulting in reduced service
life or destruction.
