17
Locking screw 10X 1/ 4 panhead Phillips
screws (for Vinyl-Clad window)(on some models)
INSTALLATION INSTRUCTIONS
3.
Check your storm windows
-- if your storm
window frame does not allow the clearance
required, correct by adding a piece of wood as
shown in Fig.E,or by removing storm window
while room air conditioner is being installed.
4 .
Check for anything that could block airflow
--
check area outside of window for things such as
shrubs, trees, or awnings. Inside, be sure
furniture, drapes, or blinds will not stop proper
airflow.
5.
Check the available electrical service-
Power
supply must be the same as that shown on the
unit serial nameplate. Power cord is 48 inches
long. Be sure you have an outlet near.
6.
Carefully unpack air conditioner-
Remove all
packing material. Protect floor or carpet from
damage. Two people should be used to move
and install unit.
Preliminary Instructions
Tools Required
A large flat blade screwdriver; Tape measure;
Adjustable wrench or pliers; Pencil; Level
Socket wrenches; Phillips Screwdriver
Hardware(Packed with the unit)
7/16 inch Locking screw and
Flat washer for window panels
3 / 4
or 1/2)inch Long
Hex-head Screw
Safety Lock
1 / 2 inch Long screw and Locknut
3 / 4 inch Long Flat Head
Bolt and Locknut
Sill Angle Bracket
Long hex-head locking
screw for top angle, side
retainer 5 /16 inch Long
2 ea.
7
1
4ea.
2ea.
2
10
Foam insert
2
Window sash
seal foam
1
A.Window Mounting
1
Remove Air Conditioner from Cabinet
1.Pull down front grille and remove filter.
(See Fig.1).
2.Lift front grille upwards and place to one side.
3.Locate the four front screws and remove.
These screws will be needed to re-install
the front panel (see Fig.2).
7. Remove shipping screws from top of unit and
also on the side by the base if installed
(see Fig.5).
8. Hold the cabinet while pulling on the base pan
handle, and carefully remove the unit.
9. Add two foam inserts to holes in top of cabinet
where shipping screws were removed from
(see Fig.6).
4.Push metal cabinet side to release plastic tabs
on each side of front panel (see Fig.3).
5.Gently lift front panel off unit(see Fig.3A).
6.Disconnect the connector plug of the display
panel from the unit and place front panel to one
side(see Fig.4).
Front Grille
Fig.1
Fig.2
Fig.3
Fig.3A
Front Panel
Fig.4
shipping
screws
Fig.5
Fig.6
R1 hardware
2
(10 *3/4 *1/12 )
NOET: R1 hardware and Weather stripping is only
for Energy star models.
Weather stripping
5
NOTE: Remove any packaging material from
cabinet exterior.
Safety Lock
(for Vinyl-Clad window)(on some models)
2
2
Lock Frame
(For Wooden
windows)(on some models)
2
3 / 4 inch Long Screw(on some models)
2
