OPTIONAL THERMOSTAT
A thermostat may help you maintain a constant house temperature
automatically. A millivolt thermostat is required. A fixed wall mount or
Breckwell’s hand held model can be used. The control panel can be
set up two ways to operate your stove in thermostat mode.
THERMOSTAT INSTALLATION
•
A MILLIVOLT THERMOSTAT IS REQUIRED.
•
Unplug stove from power outlet.
•
Remove control board from stove.
•
The two thermostat wires connect to the terminal block on the
lower left side of the back of the control board.
(See figure 21)
•
Insert the wires in the terminal side and tighten the two screws.
MODES
TO SWITCH BETWEEN ANY OF THE THREE MODES THE STOVE
MUST BE SHUT OFF, THE NEW MODE SELECTED, AND THE
STOVE RESTARTED.
MANUAL MODE
•
In this mode the stove will operate only from the control panel as
detailed in the “
OPERATION
” section of this owner’s manual.
HIGH/LOW THERMOSTAT MODE
•
When engaged in this mode the stove will automatically switch
between two settings. When warm enough, it will switch to the
#1 or low setting. The room air blower will also slow to its lowest
speed.
•
The Heat Level Advance setting on the bar graph will stay
where it was initially set. When the house cools below the
thermostat setting, the stove will switch to the feed rate of the
heat level advance setting.
ON/OFF THERMOSTAT MODE
•
In this mode when the home is warm enough the stove will shut
off. The fans will continue to run until the stove cools.
•
When the home cools below the thermostat setting, the stove
will automatically restart and run at the last feed rate setting.
NOTE:
When in “high/low” or “on/off” thermostat mode –
•
Do not operate the stove higher than the #3 setting.
Set damper control rod approximately ½” to ¾” out. This will vary
depending on elevation and weather conditions. Observe stoves
operation and adjust damper as necessary.
THERMOSTAT INSTALLATION
18
FIGURE 14
www.PelletKing.com
