Breckwell ECO-AIRE SP8000 Owner'S Operation And Instruction Manual Download Page 2

2

 

Ussc

 

IMPORTANT:

    Read  this  entire  manual  before 

installing and operating this product.  Failure to do 

so may result in property damage, bodily injury, 

or even death.  Proper installation of this heater is 

crucial for safe and efficient operation. Never use 

make-shift compromises during the installation.

 

Before  installing  your  heater,  you  must  perform 

an initial burn in an OUTSIDE environment. Follow 

the Start-Up Procedure in the Operation section 

of this manual.

 

This heater must be installed in an exterior wall or 

window to the outside.

 

Contact  your  local  building  officials  to  obtain 

a  permit  and  information  on  any  additional 

installation restrictions or inspection requirements 

in your area.

 

Save these instructions..  This manual has important 

operating  and  maintenance  instructions  that 

you will need at a later time.  Always follow the 

instructions in this manual.

 

This heater is designed and approved for premium 

hardwood pellet fuel only.  Any other type of fuel 

burned in this heater will void the warranty and 

safety listing.

 

Never  use  gasoline,  gasoline-type  lantern 

fuel,  kerosene,  charcoal  lighter  fluid,  or  similar 

flammable liquids to start or “freshen up” a fire in 

this heater.  Keep all such liquids well away from 

the heater while it is in use.

 

A working smoke detector must be installed in the 

same room as this product.

 

Do  not  unplug  the  heater  if  you  suspect  a 

malfunction.  Turn the ON/OFF SWITCH to ”OFF’ 

and contact your dealer.

 

Do not operate your heater with the viewing or 

combustion door open.  The auger will not feed 

pellets under these circumstances and a safety 

concern may arise from sparks or fumes entering 

the room.

 

Never disable or bypass the safety devices in this 

unit. Doing so could result in damage to the unit 

or endanger yourself or someone else. 

 

Your  heater  requires  periodic  maintenance 

and cleaning (see ”MAINTENANCE ”). Failure to 

maintain your heater may lead to improper and/

or unsafe operation.

 

Never  try  to  repair  or  replace  any  part  of  the 

heater unless instructions for doing so are given 

in this manual.  All other work should be done by 

a trained technician.

 

Turn the heater OFF and allow to completely cool 

before performing any maintenance.

Safety Precautions

 

Disconnect the power cord before performing any 

maintenance!  NOTE: Turning the ON/OFF Switch 

to  ”OFF”  does  not  disconnect  all  power  to  the 

electrical components of the heater.

 

Ashes must be disposed in a metal container with 

a tight fitting lid.  The closed container of ashes 

should be placed on a non-combustible surface 

or on the ground, well away from all combustible 

materials, pending final disposal.

 

The exhaust system should be checked bi- monthly 

during  the  burning  season  for  any  build-up  of 

flyash, soot or creosote. 

 

HOT  WHILE  IN  OPERATION.  KEEP  CHILDREN 

CLOTHING AND FURNITURE AWAY. CONTACT MAY 

CAUSE SKIN BURNS. Do not touch the hot surfaces 

of the heater.  Educate all children on the dangers 

of  a  high-temperature  heater.  Young  children 

should be supervised when they are in the same 

room as the heater.

 

A power surge protector is required.  This unit must 

be  plugged  into  a  110  -  120V,  60  Hz  grounded 

electrical  outlet.  Do  not  use  an  adapter  plug 

or  sever  the  grounding  plug.  Do  not  route  the 

electrical cord over the heater.  Do not route the 

cord in foot traffic areas or pinch the cord under 

furniture.

 

The  heater  will  not  operate  during  a  power 

outage. If a power outage does occur, check the 

heater for smoke spillage and open a window if 

any smoke spills into the room.

 

Never block free airflow through the open vents 

of the unit.

 

Keep foreign objects out of the hopper.

 

The moving parts of this heater are propelled by 

high torque electric motors.  Keep all body parts 

away from the auger while the heater is plugged 

into an electrical outlet.  These moving parts may 

begin  to  move  at  any  time  while  the  heater  is 

plugged in.

 

Do not place clothing or other flammable items 

on or near this heater. 

 

WARNING—DO  NOT  INSTALL  THIS  UNIT  IN  A 

SLEEPING  ROOM.    CAUTION—THE  STRUCTURAL 

INTEGRITY  OF  THE  MOBILE  HOME  FLOOR,  WALL, 

AND CEILING/ROOF MUST BE MAINTAINED.

 

This appliance is not intended for commercial use.

 

DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST 

VENTING SYSTEM OF THIS UNIT.

 

DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE 

SERVING ANOTHER APPLIANCE.

 

DO NOT USE CHEMICALS OR FLUIDS TO START THE 

FIRE;  DO  NOT  BURN  GARBAGE  OR  FLAMMABLE 

FLUIDS SUCH AS GASOLINE, NAPHTHA OR ENGINE 

OIL.

Summary of Contents for ECO-AIRE SP8000





















Reviews: