SPEAKER SIGNALS
ALL PORT CONNECTION
IV. Connecting the Allport to the Elevate 6.6 amplifier
When the Allport is installed in the wall the only part visible should be the
faceplate with a 25 pin connector for the Speaker Allport Cable and a single
RJ45 jack. The supplied Allport Cable and the pre-terminated network cable
can then be plugged into the appropriate jack on the Allport and into the
Speaker Signal and Network connections on the back of the Elevate 6.6
amplifier, Fig. 4.
Elevate 6.6 Network
Connection
Elevate 6.6 Allport
Speaker Connection
V. Attaching Audio Source Equipment to the Elevate 6.6 Amplifier
Each piece of audio source equipment is connected to the Elevate 6.6 amplifier
with standard stereo RCA cables. Attach the RCA cable to the corresponding
audio output on the source equipment and to the desired source input on the
back of the Elevate 6.6 amplifier, Fig. 5.
Source 1
Tuner 1
Audio
Out
VI. Connecting the IR Emitters
IR commands for the source equipment are transferred from the Elevate 6.6
amplifier to the source equipment via mini IR mouse emitters. Six of these are
supplied with your Elevate 6.6 System. The emitter is plugged into the
corresponding source IR output on the Elevate 6.6 and then placed over the IR
receiver window on the source component, fig. 6. The IR outputs are
individually routed to sources 1-6 allowing IR commands from the chosen
source to only control that source.
The two SUM outputs will flash any IR command that is sent from any of the
zones. This can be used with an IR blaster designed to flash IR commands to a
variety of components. This is done by plugging a single mono 1/8” patch
cable into the SUM IR output and into the Direct IR input on the blaster.
Fig. 4
Fig. 5
Fig. 6
8
CONNECT TO
BA-6640AP
NETWORK
Allport (front)
Network Cable
Allport Cable
ZONE 1
ZONE 2
ZONE 3
SOURCE LINK
L
R
L
R
L
R
SOURCE INPUTS
1
2
3
4
5
6
1
2
3
4
5
6
CONNECT TO
BA-6640X
USE BA-SLC1
CABLE
ZONE 1