BRAYER BR4961WH, Instruction Manual, Page: 7 / 36

7 EN
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. No additional actions
are required when the device is used in the mains
with 60 Hz frequency.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
FAN ASSEMBLY
• Unscrew the mounting screws from the Base (1).
• Install the Lower Telescopic Pole (3) onto the Base
(1) and secure it with mounting screws.
• Unscrew and remove the Lock (4), rotating in
counterclockwise, install the Decorative Panel (2)
onto the Telescopic Pole (3).
• Reinstall the Lock (4), rotating it clockwise, following
the thread.
• Extend the Extension of the Pole (5) at the necessary
height, secure it, applying limited force to the Lock (4)
and turning it clockwise.
• Loosen the fan Lock (11), rotating it
counterclockwise.
• Install the fan all the way onto the Telescopic Pole
Extension (5), secure it with the Lock (11), do not
apply excessive force while screwing the Housing
Unit (10) in to avoid damaging the extendable part of
the Telescopic Pole (5).
• Align the bumps on the Housing Unit (10) to the
corresponding openings in the Grill (16) and install
the Rear Grill onto the Housing Unit (10) with the
Carrying Handle (8) on top.
• Secure the Rear Grill (16) with the Ring (15), rotating
it clockwise, following the thread.
• Install the Blades (14) onto the Motor Axis (17),
secure them with the Lock (13) by turning it in a
counter-clockwise direction, following the thread
while holding the Blades (14) down with the free
hand.
• Open the Grill Locks (7), join the Front and Rear
Grills (12, 16), close the Locks (7), making sure that
the Grills have been properly secured (12, 16).
• The fan is ready for operation.
FAN USAGE
• Place the unit on a dry flat surface.
• Loosen the Tilt Lock located below the Housing Unit
(10), tilt the Housing Unit as needed and lock it, by
turning it clockwise.
• Connect the power plug to an electrical outlet.