BRAYER BR4880, Instruction Manual

Page: 9 / 44

9 EN
• To avoid mains overloading, do not switch on several
electrical appliances with high power consumption at
the same time.
• Insert the power plug into the mains socket.
• Set the power switch (3) to the required position:
- «0» —the unit is off;
- «I» — the unit is switched on.
• Turn the thermostat knob (2) clockwise as far as
it will go. When the air temperature in the room
reaches the desired value, turn the thermostat knob
(2) counterclockwise until you hear a distinctive click;
in this position the thermostat will maintain the set air
temperature in the room automatically.
• To increase the air temperature in the room, turn the
thermostat knob (2) clockwise and counterclockwise
to decrease it.
Note: the fan heater will not switch on if the thermostat
settings correspond to the air temperature in the room.
• AAfter operation turn the thermostat knob (2)
counterclockwise until bumping, set the power switch
(3) to the position «0» and unplug the unit.
Note:
when you switch the unit on for the first time,
some smoke or foreign odor may appear. It is normal
and not covered by warranty.
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
• If the outgoing air temperature exceeds the
acceptable value, the automated thermal switch will
switch off the convection fan heater.
• Set the power switch (3) to the position «0»
and unplug the unit, let the unit cool down for
approximately 15-25 minutes (depending on the air
temperature in the room) and only after that you can
switch the unit on again.
• Make sure that the upper and bottom air grids are not
blocked with foreign objects.
• Insert the power plug into the mains socket and
switch the unit on.
• If the convection fan heater does not switch on, it
may be caused by another malfunction. In this case
apply to a service center for repairing of the unit.
PROTECTION FROM DROPPING
• If the convection fan heater accidentally falls or tilts
too much, the fall protection system will switch off
the unit.
• Set the convection fan heater into the vertical
position, and the unit will resume operation.
Note: place the unit on an even dry and steady surface
to prevent it from dropping.